117 - AG-C03 | Turbine Generator Detailed Workface Verification
Buy 4 Checklists, Get 1 Free
ORIGINAL TURBINE AND ROTATING MACHINE PURPOSE
Genuine source-original AVC AG-C03 editable Word for maintenance contractors working on Power Plants Turbines, Generators and Rotating Machinery in an industrial outage. Its purpose is turbine generator detailed workface verification. Large shaft stored energy, bearing contamination, off-centre rotor lifts and unverified alignment can cause serious damage or danger when machine configurations change.
WHEN TO COMPLETE THIS ORIGINAL
Enter the real CONTRACT / UNIT, WORK PACKAGE / ASSET, DATE / SHIFT and PERMIT / REVISION or the printed SITE / UNIT, WORK ORDER / REV and WORK AREA / ZONE. Match machine and shaft tags to current plant drawings and outage configuration. Confirm authorised electrical/steam/lube/gravity isolation, blocked shaft and turning gear, certified lift fixtures, bearing/journal protection, clean-zone FME and competent facility-area authority.
ACTUAL PRINTED WORD CONTENT
Nine actual detailed workface controls: correct unit/shaft line and outage revision, complete electrical/steam/lube/stored rotational isolation, restrained turning gear, certified rotor lift tooling, protected journals/FME, engineered stands/rigging, baseline vibration/runout, calibrated metrology, component clearances and torque traceability.
REQUIRED MEASUREMENT AND EVIDENCE
Document genuine as-found and as-left clearances, bearing temperatures, runout and vibration, alignment, fastener torque and instrument calibration with equipment serial, competent technical inspector, approved limits and real signed evidence. Record unexpected movement, lubricant loss, damaged bearings or testing deviations as HOLD. Attach current ITP, drawing revisions, lift and rotor protection records and traceable disposition for every open defect.
INDEPENDENT OPERATOR CONTROL AND RUN AUTHORISATION
Only the plant operator and authorised technical machinery owner release turbine/generator internals, safe lifting conditions, shaft handling, turning gear, overspeed tests and controlled start. A contractor checklist is not isolation, movement or energisation authority. Missing overspeed protection, disabled guards or lubrication must prevent test runs, and the named control-room controller must accept every hold gate.
ORIGINAL EDITABLE WORD AND PACKAGE CHOICES
R12.95 for this authentic source-identical AVC Word Single. Already included in the full 277-document Power Generation & Industrial Outage Checklist Package and 525-page Contractor H&S File; avoid duplicate purchase. Eligible Singles may qualify for BUY 4 GET 1 FREE while checkout cart offer is active (5 pay for 4, 10 for 8, 15 for 12). Verify cart; packages excluded.
